Contents: Checking the turn signal switch ↓ Checking the hazard warning switch ↓ Checking the turn signal relay ↓
Checking the turn signal switch
Cm. Checking the combination switch.
Checking the hazard warning switch
If the conductivity does not match the table, replace the switch.
Checking the turn signal relay
1. Connect the battery to terminals "2" (+) and "3" (-) of the relay.
2. Connect two turn signal lamps (21 W) in parallel to terminals "1" and "3". Make sure that the lamps flash at a frequency of 60-120 times per minute.
3. If one of the turn signal lamps burns out, the flashing frequency will be more than 140 times per minute.
4. If the turn signal flasher does not operate as described, replace it (first, make sure that the lamp power corresponds to the nominal power).