Lighting and light signaling system Lighting and signaling systems include: headlights, taillights, brake lights, reversing lights, direction indicators, fog lights, license plate lights and interior lights. Dashboard lighting devices are discussed in the...
List of lamps To be able to replace a burned-out bulb, you must have a set of spare bulbs in your car. The table below contains a list of the main lamps used in the COROLLA. Incandescent lamp, 12 V Lamp category Power high/low beam...
Replacing outdoor lamps Turn off the corresponding lamp. Headlights Open the hood. Only for vehicles with 105 hp engine: Loosen the wing nut of the intake port on the right headlight. Open the hose holder and pull the suction port upwards. In...
Replacement of interior lighting lamps Turn off the corresponding lamp. Indoor lamps (All) and trunk lighting (except Combi) Interior lighting: Remove the diffuser by prying it out with a screwdriver. Trunk lighting: Unscrew the two screws securing the...
Removal and installation of a headlight Farah doesn't understand. In case of damage, such as a lens, the headlight is replaced completely. Removing Turn off headlight. Open the hood. Disconnect the plug connection of the lamp. Loosen the screws securing the...
Headlight adjustment Proper headlight adjustment is essential for safe driving. Fine adjustment of the headlight is possible only with the use of a special device. For this reason, only the points where adjustment can be made and the...
Removal and installation of a back lantern Removing Remove the lamps of the corresponding lamp . Liftback and Limousine. If the rear light is in the sidewall, loosen the nuts from the inside and remove the light. Remove the rubber gasket between the lamp and the...
Removing and installing the antenna The car radio can be operated with a conventional rod antenna or an electronically amplified roof-mounted antenna. Antenna Removal Instructions Remove the radio and disconnect the antenna wire. Attach a tape or cord to...