- A) Using a centering mandrel, install the disc and clutch cover.
- b) Align the alignment marks on the clutch cover and flywheel.
- V) Temporarily tighten bolts #1 and #2.
- G) Tighten the clutch cover mounting bolts in several stages, in the sequence shown in the figure. Tightening torque 19 Nm.
2. Check the mutual arrangement of the ends of the petals of the diaphragm spring. Maximum deviation from the plane: 0.5 mm.
If the deviation exceeds the allowable value, then adjust the relative position of the ends of the spring petals.
3. Apply grease to the surface of the following parts:
- clutch release forks and release bearing at the points of their contact;
- clutch release forks and working cylinder rod at their points of contact;
- at the ball bearing point of the clutch release fork;
- on the splines of the clutch disc.
4. Install the release bearing on the clutch release fork and then install them on the gearbox.
5. Install the gearbox.