Note: This procedure applies to 1999-2003 models only. 2004 and later models do not use an accelerator cable.
1. Remove the engine cover (see paragraph "Intake manifold - removal and installation" in Chapter 2).
2. Loosen the accelerator cable lock nut and unscrew the cable adjustment nut (Fig. 10.2), then release the cable from the corresponding bracket.
Fig. 10.2. Loosen the lock nut (A) and adjusting nut (B), then slide the cable out of the bracket
3. Disconnect the accelerator cable from the throttle cams: align the cable with the groove on the side of the cam, then slide the cable end out of the cam (Fig. 10.3).
Fig. 10.3. Align the cable with the groove on the side of the cam, then slide the end of the cable out of the cam (v6 model shown, similar for four-cylinder engines)
4. Trace the accelerator cable back to the bulkhead, note the cable routing pattern and disconnect any cable clamps or guides.
5. Move the cable away from the accelerator pedal (in the passenger compartment) (Fig. 10.5).
Fig. 10.5. To disconnect the cable from the accelerator pedal, pull the cable end (A) out of the pedal and then slide the cable out of the groove on the left side (B)
6. Unscrew the bolts and disconnect the cable from the partition (Fig. 10.6).
The full article is posted on the website (Toyotaman.ru)
Fig. 10.6. To disconnect the accelerator cable from the bulkhead, check the two bolts
7. Pull the cable through the bulkhead on the engine compartment side.
8. Installation is performed in the reverse order of removal.