Note. The tempostat drive hummock is adjusted in a similar manner.
Removing
1. Disconnect the negative cable from the battery.
Attention! If the stereo system installed in the car is equipped with a security code, before disconnecting the battery, make sure that you have the correct combination to activate the audio system!
2. Loosen the locknut of the threaded lug that secures the cable to the throttle actuator lever (see accompanying illustration).
3. Turn the lever to release the tip of the cable from it.
4. Disconnect the cable from the gas pedal and unscrew the two screws that secure the shell of the cable assembly to the bulkhead of the engine compartment.
5. Retract the cable into the engine compartment.
Installation and adjustment
1. Installation is carried out in the reverse order, make sure that the rubber bushing is firmly seated in the hole in the bulkhead.
2. Squeeze out the gas pedal to the stop and make sure that the throttle valve is fully opened.
3. If the damper does not open fully, loosen the locknuts, depress the pedal and adjust the cable accordingly.
4. Tighten the locknuts, make sure the damper closes completely when the pedal is released.