Installation
1. Set the vehicle's wheels to the straight ahead position.
2. Install the coiled wire.
A) Install the coiled wire on the combo switch by aligning the grooves as shown in the figure.
b) Connect the combination switch connector.
Front passenger airbag module.
1 - front passenger airbag module.
Driver airbag module.
1 - airbag module,
2 - steering wheel.
V) Lock the coiled wire by turning it counterclockwise.
b) Turn the coiled wire all the way 90°clockwise, then turn it counterclockwise to align the coiled wire position indicator dowel marks.
Spiral wire.
1 - spiral wire,
2 - combined switch.
3. Install the airbag module assembly with the steering wheel pad.
Removing
1. Set the ignition switch to the "OFF".
2. Disconnect a wire from the negative plug of the storage battery.
3. Set the vehicle's wheels to the straight ahead position.
4. Remove the lower finishing panel from the driver's side.
5. Remove the lower casing of a steering column.
6. Turn away two bolts and two nuts and remove the top casing of a steering column.
7. Remove the airbag module assembly with trim and steering wheel.
8. Disconnect the combination switch connector and remove the coiled wire.