Ignition system of car engines Toyota Dyna (100/150)

Precautions when working with the ignition system
1. Do not leave the ignition system on for more than 10 minutes when the engine is not running. 2. (Contact (classic) ignition system) When connecting the tachometer, connect the tachometer test lead (probe) 3....

Electronic ignition timing control
The electronic control unit (ECU) is set to the optimum ignition timing values for all engine operating modes. Using signals from sensors measuring the main engine parameters (crankshaft speed, absolute pressure in the...

Checking the ignition system on a car
Checking for "spark" Check for spark (Contact ignition system): a) Disconnect the high voltage wire from the distributor. b) Holding the wire at a distance of approximately 12.5 mm from the car body ("ground"), turn on...

Distributor (contact ignition system) — disassembly, inspection and assembly
Disassembly 1. Remove the distributor cover without disconnecting the wires. 2. Remove the distributor rotor and dust deflector (if installed). 3. Disconnect the distributor wire and terminal. a) Unscrew the nut and...

Distributor (contactless ignition system without electronic control of the ignition timing)
Disassembly 1. Remove the distributor cap without removing the high-voltage wires. 2. Remove the distributor rotor. 3. Remove the protective cover (dust deflector) ignition coils. 4. Remove the protective cover (dust...

Distributor (contactless ignition system with electronic control of the ignition timing)
Disassembly 1. Remove the distributor cap without removing the high-voltage wires. 2. Remove the distributor rotor. 3. Remove the protective cover (dust deflector) ignition coils. 4. Remove the ignition coil. a) Unscrew...

Checking distributors after disassembly
1a. (Contact ignition system) Check the contact plate for a small amount of play between the plate elements as shown in the figure. If there is any binding or strong resistance, replace the plate. 1b. (Contactless...

Adjusting the axial clearance of the drive shaft (distributor or centrifugal regulator)
Replacing the driven gear 1. Remove the driven gear. a) Use a grinding stone to file down the projection of the driven gear connecting pin, being careful not to damage the drive shaft. b) Use a punch and a hammer to...

Installation of distributors
1. a) Set the piston of the first cylinder to the position corresponding to TDC at the end of the compression stroke. Remove the spark plug of the first cylinder, close the spark plug hole with your finger and rotate...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Ignition system Toyota Corolla E80 (1983-1990)
➥ Ignition system Toyota Carina T170 (1988-1992)
➥ Ignition system Toyota 4Runner N120 (1989-1995)
➥ Ignition system Toyota RAV 4 XA10 (1994-2000)
➥ Ignition system Toyota Corona T190 (1992-1997)

Link in different formats to this article

TEXTHTMLBB Code