Car clutch repair Toyota Dyna (100/150)

Checking and adjusting the clutch pedal
1. Check the correct height of the pedal and free travel of the pusher. Pedal height - 178 mm Free travel of the pusher on the top of the pedal - 1 - 5 mm In case of deviation from the specified values, it is necessary...

Bleeding the clutch hydraulic drive
Note: Bleeding is performed after any disassembly of the hydraulic system (removing the master or slave cylinder, replacing the tubes) or if you suspect that air has entered the system. 1. Fill the reservoir with brake...

Clutch master cylinder
Removal the master cylinder 1. Pump out the fluid 2. Remove the cotter pin and pull out the fork mounting pin. 3. Disconnect the hose. 4. Disconnect the clutch hydraulic line. 5. Loosen the mounting bolts and remove the...

Clutch slave cylinder
Removal the slave cylinder 1. Disconnect the clutch hydraulic line. 2. Unscrew the two bolts and remove the slave cylinder. Disassembling the slave cylinder 1. Pull out the rod. 2. Remove the cover. 3. Remove the piston...

Clutch — removal, inspection of parts and installation
Removal 1. Remove the gearbox. Note: Draining the gearbox oil is not necessary. 2. Remove the clutch housing assembly and the clutch driven disc. a) Apply alignment marks on the clutch housing and flywheel. b) Loosen...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Clutch Toyota Corolla E80 (1983-1990)
➥ Clutch Toyota 4Runner N120 (1989-1995)
➥ Clutch and cardan Toyota Camry Vista V40 (1994-1998)
➥ Clutch Toyota Corona T190 (1992-1997)
➥ Clutch Toyota RAV 4 XA10 (1994-2000)
➥ Clutch Toyota Cruiser 70 (1985-1996, diesel)

Link in different formats to this article

TEXTHTMLBB Code