Checking and changing the oil in the manual transmission 1. Park the vehicle on a level surface. 2. Remove the filler plug. 3. Make sure that the oil level in the gearbox housing is under the cut of the filler plug. Add oil to the crankcase if necessary. 4. The oil level in...
Removing the gearbox Note: When removing and installing the gearbox, follow the assembly drawing "Transmission". Install in the reverse order of removal. After installation, adjust the clutch pedal. When removing, pay attention to the...
Replacement of power shaft seals Replacement of power shaft seals. 1 - oil seals 1. Disconnect drive shafts. 2. Using a special tool, remove the oil seal from the gearbox housing. 3. Install and press in a new oil seal. 4. Connect the drive shafts.
Removal and installation of the switch of lanterns of a backing Removal and installation of the switch of lanterns of a backing. 1 - reversing light switch. 1. Disconnect the reversing light switch wire connector and remove the gasket. 2. Make sure there is continuity between the...