Valve clearance Check and adjustment 1. Remove the air filter. 2. Remove the ignition coils and cylinder head cover. 3. Turn the crankshaft until the alignment mark is aligned with the pointer on the timing belt cover. 4. Make sure...
Timing belt Removing 1. Disconnect a wire from the negative plug of the storage battery. 2. Remove the front bumper. 3. Remove the coolant pump pulley by securing the pulley from turning with a screwdriver. 4. Remove the crankshaft...
Cylinder head — removal and installation Removing 1. Remove accessory drive belts, coolant pump pulley and alternator. 2. Remove the coolant pump plug and drain the coolant. 3. Remove the timing belt (see section " timing belt "). 4. Fix the camshaft with a...
Power unit assy Removing 1. Relieve residual fuel pressure (see chapter " fuel injection system "). 2. Remove the battery. Note: read the diagnostic code before disconnecting the battery. 3. (Models with manual transmission) Disconnect...
Intake manifold Removing 1. Drain the coolant. 2. Disconnect a wire from the negative plug of the storage battery. 3. (Models with automatic transmission) Disconnect the throttle valve control cable (from the engine side). 4....
An exhaust manifold Removing 1. Disconnect a forward reception pipe of system of release. 2. Remove the heat shield. 3. Remove the oxygen sensor. 4. Remove the exhaust manifold. Installation 1. Clean the contact surfaces of the cylinder...