Transfer case — removal Note: when removing, follow the assembly drawing "Transfer case". When removing, pay attention to the following operations: 1. Hang the motor on the hoist. 2. Lower the subframe (see chapter " Manual Transmission "). 3....
Transfer case — installation Install in the reverse order of removal. When installing, pay attention to the following operations: 1. Install O-rings on transfer case, press fit and apply grease. 2. Install the rear engine mount bracket: A) Install...
Cardan shaft — removal and installation Note: Install in the reverse order of removal. 1. Turn away bolts of fastening of an arm of the central basic bearing and remove an arm. 2. Mark the propeller shaft flange and the automatic four-wheel drive clutch. 3....
Cardan shaft — check 1. Check the cardan shaft. A) Check for damage to the cardan shaft. b) Check driveshaft runout. If the runout is greater than the maximum, then replace the cardan shaft. Maximum runout - 0.5 mm 3. Check cross bearings....
Replacing the front oil seal of the rear axle gearbox Replacing the front seal. 1 - cover, 2 - retaining ring, 3 - clutch for automatic inclusion of all-wheel drive, 4 - stuffing box. Removing 1. Remove the cover. Note: Be careful not to damage the 4WD auto clutch. 2....
Checking and changing the rear axle gear oil 1. Park the vehicle on a level surface. 2. Remove the filler plug. 3. Make sure that the oil level in the gearbox housing is under the cut of the filler plug hole. Add oil to the crankcase if necessary. 4. The oil level...
Drive shafts — removal Note: Do not damage the drive shafts when clamping them in a vise. 1. Turn away a nut of fastening of a power shaft to a nave. 2. Using a special tool, remove the tie rod. 3. Remove the retaining ring and use a plastic...
Drive Shafts — Installation Note: install in the reverse order of removal. When installing, pay attention to the following operations: 1. Install the drive shaft. A) Apply special grease to the surface of the inner joint. b) Establish a shaft of...
Checking the drive shafts (2WD models with manual transmission and 4WD) 1. Check the balls of the inner race of the inner joint for damage. 2. Check the outer joint splines for damage. 3. Check the splines of the inner race of the inner joint for damage. 4. Check that the dust covers are...
Drive Shafts — Assembly 1. Install the dust cover and temporarily fix it with the clamps. 2. Install the inner race of the inner joint. 3. Install o-rings. 4. Install the outer race of the inner joint and put on the retaining ring. 5. Install...
Disassembly of drive shafts (2WD models with automatic transmission) 1. Remove the inner hinge dust boot clamps. Note: do not damage the boot. 2. Lower the dust cover. 3. Remove the inner hinge. A) Remove grease from the hinge. b) Place marks on the outer race of the joint and on the...