Checking and replacing the coolant The procedures for checking and replacing the coolant are described in the chapter " Maintenance and general inspection and adjustment procedures ".
Coolant pump (KZ series) — removal and installation Removal and installation of the pump of a cooling liquid (KZ series). 1 - pulley, 2 - coolant pump, 3 - gasket. 1. Drain the coolant. 2. Remove the accessory drive belt. 3. Remove the coolant pump pulley. Tightening...
Coolant pump (EJ-series) Removal and installation 1. Disconnect a wire from the negative plug of the storage battery. 2. Drain the coolant. 3. Remove the accessory drive belt. 4. Remove the viscous fan clutch. Tightening torque - 14 Nm 5....
Thermostat — removal and installation Removing 1. Disconnect a wire from the negative plug of the storage battery. 2. Drain the coolant. 3. Turn away nuts and remove an inlet branch pipe (1) coolant and remove the thermostat (2). KZ series. EJ series....
Radiator — check 1. Remove the radiator cap. Attention: on a hot engine, this operation must be carried out with care to avoid burns from hot water jets or steam. 2. Check the radiator cap using a radiator tester. Note: If there are...
Electric fan (KZ series) Vehicle checks 1. Checking on a cold engine (coolant temperature less than 80°C). Turn on the ignition (ON) and make sure the fan is not spinning. 2. Checking on a warm engine (coolant temperature over 100°C). A) Warm...