Valve clearance — check and adjustment 1. Remove the ignition coils and cylinder head cover. 2. Set the piston of the first cylinder to the TDC of the compression stroke. A) Rotate the crankshaft and align the mark on the pulley with the mark on the timing...
Timing chain Removing 1. Relieve residual fuel pressure (see chapter " fuel injection system (EFI) "). 2. Remove the battery from the pallet. Note: when the wire is disconnected from the battery, the volatile memory of the ECU,...
Cylinder head Removing 1. Relieve residual fuel pressure (see chapter " fuel injection system (EFI) "). 2. Remove the battery from the pallet. Note: when the wire is disconnected from the battery, the volatile memory of the control...
Camshafts Removing 1. Disconnect a wire from the negative plug of the storage battery. 2. Remove the air filter. 3. Remove the accessory drive belt. 4. Remove ignition coils. 5. Set the piston of the first cylinder to the TDC of...
Power unit Removing 1. Relieve residual fuel pressure. 2. Remove the battery. 3. Remove the air filter. (Models with manual transmission) Remove the clutch release cable. 5. Drain the coolant. 6. Remove the radiator. 7. Remove the...
Air filter Removal and installation 1. Disconnect a wire from the negative plug of the storage battery. 2. Remove the intake air pressure sensor, the intake air temperature sensor, disconnect the connector of the electro-pneumatic...
Intake manifold Removing 1. Drain the coolant. 2. Disconnect a wire from the negative plug of the storage battery. 3. Remove the air filter. 4. Remove the throttle body (see chapter " fuel injection system (EFI) "). 5. Disconnect all...
An exhaust manifold Removing 1. Drain the coolant. 2. Disconnect a forward reception pipe of system of release. 3. Remove the ground screw. 4. Remove the power steering pump drive belt. 5. Remove the power steering. Note: Do not disconnect...