Electrical equipment and devices of the car Toyota Duet

Body electrical equipment — general information
Precautionary measures 1. Before working on electrical equipment, disconnect the cable from the negative terminal of the battery. 2. If it is necessary to disconnect the battery for a check or repair, be sure to first...

Relays and fuses
Relay block (Sirion). 1 - starter relay, 2 - electromagnetic clutch relay, 3 - condenser fan motor relay, 4 - cooling system fan motor relay, 5 - main relay of the injection system, 6 - fuel pump relay, 7 - ignition...

Crash sensor — check
1. If the sensor wire break lasts more than 200 ms, a buzzer sound is heard for 5 s. When the fault is eliminated, the lock opening system should not operate in emergency mode. 2. If the sensor circuit is...

Speed sensor and hazard warning light sensor — check
Check the speed sensor, interior lighting and hazard warning light for proper operation under the following conditions: a) Switch the interior lighting towards the door. b) Set the vehicle speed to 15 km/h. c) Stop the...

Driver's Door Lock Control Switch — Check
Check for continuity between the connector terminals at different switch positions. Switch in position "LOCK" — "4"←→"6" Switch in position "UNLOCK" — "5"←→"6"

Electric door lock drive — check
Front doors. Rear side and rear door. Check the operation of the electric drive by connecting the connector leads to the positive or negative terminal of the battery and in various positions of the driver's door lock...

KEY FREE System
Checking the internal and external antenna Check the range of the system's internal and external antennas according to the figure "Checking the internal and external antennas". Diagnostics Initial conditions: The master...

Checking components
1. Checking the restart switch. Turn the ignition switch to the "LOCK" position and check the conductivity between terminals "3" and "8" of the connector. Switch in "NORMAL" position - no conductivity Switch in the...

Instrument cluster
Disassembling and assembling the instrument cluster When disassembling and assembling, refer to the assembly drawing "Instrument cluster". Checking the speedometer 1. Connect a calibration speedometer and make sure that...

Headlights and lighting
Precautions when replacing lamps 1. Do not touch the glass part of the lamp as this will reduce its service life. 2. If oil gets on the lamp bulb, remove it, otherwise the lamp life will be significantly reduced due to...

Electric window lifters
Self-diagnosis 1. Turn on the ignition. 2. Lower the door glass for 2 seconds or more (in manual mode). 3. If there is a malfunction, the "AUTO" indicator will display its code. Note: the indication lasts for 30 seconds...

Electric mirrors
Checking the operation of the folding mechanism 1. Turn the ignition switch to the "ACC" position. 2. Check the operation of the folding mechanism in different mirror positions (see table "Checking the operation of the...

Navigation system
Checking the multifunction display The check is carried out according to the table "Checking signals at the terminals of the multifunction display connectors". Removal and installation the GPS receiver When removing and...

Main technical data of the body electrical system
Specifications

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Equipment and devices Toyota Highlander 1 (2000-2007, petrol)
➥ Equipment and devices Toyota 4Runner N120 (1989-1995)
➥ Equipment and devices Toyota Corona T190 (1992-1997)
➥ Equipment and devices Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Equipment and devices Toyota Corolla E80 (1983-1990)
➥ Equipment and devices Toyota RAV 4 XA10 (1994-2000)

Link in different formats to this article

TEXTHTMLBB Code