OBD II system computer (Powertrain Control Module) [Toyota Camry XV20]

Typical PCM module mounting

1. Module; 2. Side paneling; 3. Threshold lining; 4. Connector; 5. Bottom cover; 6. Bottom panel

Removal

1. Disconnect the battery from ground.

2. Remove the glove box.

3. Disconnect the connector from the module (the ignition must be off) and unscrew the mounting bolts.

4. Remove the module carefully, taking care not to damage it with static electricity.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kolokoltsev Grigory

Share information:

◀ Previous

Camry XV20: Exhaust system

Next ▶

OBD II Emissions Diagnostic System
Technical characteristics of the toxicity reduction system
Installation locations of emission control system units
Exhaust system maintenance

Throttle Position Sensor — Checking and Replacing
Manifold Absolute Pressure Sensor
Mass Air Flow Sensor — Checking and Replacing
Intake Air Temperature Sensor (IAT Sensor)
Coolant Temperature Sensor (ECT Sensor)