Engine oil and filter The procedures for checking the engine oil level, changing the oil filter and changing the oil are described in the chapter " Maintenance and general inspection and adjustment procedures ".
Oil pressure check 1. Check the oil level. 2. Using the special tool, unscrew the emergency oil pressure switch. 3. Using an adapter, install a pressure gauge in place of the oil pressure sensor. Series K3 EJ-series 4. Warm up the engine...
Oil pump (KZ series) Removal and installation 1. Remove the oil pan (see section " oil pan "). A) Turn away bolts and nuts of fastening of the pallet. b) Insert the blade of the special tool between the oil pan and the cylinder block and,...
Oil pump (EJ-series) Removal and installation 1. Unscrew the oil filter. 2. Remove the oil pan (see section "oil pan"). A) Turn away bolts and nuts of fastening of the pallet. Tightening torque - 9 Nm b) Insert the blade of the special tool...
Oil pan (KZ series) Removing 1. Drain the coolant. 2. Drain the engine oil. 3. Disconnect a wire from the negative plug of the storage battery. 4. Remove the front right wheel. 5. Remove the lower engine protection. 6. (Models with manual...
Oil pan (EJ-series) Removing 1. Drain the coolant (see chapter " Maintenance and general inspection and adjustment procedures "). 2. Drain the engine oil. 3. Remove the lower engine protection. 4. Remove the oil pan. A) Loosen the oil pan...