2. Stop the engine, apply the parking brake and block the wheel diagonally opposite the one to be replaced.
3. Insert the jack only into the designated places shown in the figure.
Attention:
- Install the jack only in the recommended position. If the jack is installed incorrectly, dents may form in the car body or the jack may fall, injuring you.
- Avoid installing the jack on a slope or unstable surface. Otherwise, the jack may tilt and move from the installation position or fall, which may cause an accident. Always install the jack on a flat, hard surface.
- Before installing the jack, make sure that there is no sand or small stones on the supporting surface.
4. Assemble the jack handle as shown in the figure.
(The article is taken from a web resource: www.ToyotaMan.ru)
5. Turn the handle to the right to jack up the car.
6. After completing the work, lower the vehicle and fold the jack.