Attention: To avoid damage to the protective varnish layer, do not allow tire workers to clean the outer surface of the wheel with a wire brush and, when replacing the adhesive balance weights, remove them with a screwdriver.
1. If the wheels were rearranged, replaced or repaired, then after the first 1600 km, check the reliability of the fastening of the nuts.
2. Use wheel nuts and wrench "Toyota", specially designed for aluminum rims.
3. When balancing the wheels, use special weights for aluminum wheels, as well as a plastic or rubber mallet.
4. Periodically check aluminum rims for damage (cracks and chips). If there is any damage, replace the wheel immediately.
5. When replacing tires with a directional tread pattern, check that they are installed correctly.