General description of the heating system Air for heating is sucked in through the grate under the windshield of the car and is supplied by a fan to the passenger compartment. In this case, the air, passing through the heater casing and through the dampers, is...
Fan resistor — check, removal and installation Attention: If the heater fan does not work at one stage, then, as a rule, the resistor is damaged. In this case, the board is completely replaced. Look rice. G-5201 . Examination Disconnect ground cable (-) from the...
Removal, installation and adjustment of heater control rods The heater control rods should be replaced if the control levers move heavily and unevenly. Removing Loosen the heater cover fixing screws area of control levers . Remove 4 screws and remove heater control levers....
Removing and installing ventilation nozzles Removing The ventilation nozzles are fixed in the front panel and removed with a small screwdriver. Placing and Removing Ducts shown here . Installation Install the nozzles in place and press down.