Manual gearbox Corolla Verso 3 (AR10)

General information about manual transmission
Fig. 3.54. Gearboxes installed on Corolla Verso vehicles The new Corolla Verso models are equipped with the following types of manual transmissions in a block with the main gear: C251, E358 and C251A*. In general, the...

Manual transmission in block with final drive C251
Gear shift mechanism Fig. 3.55. Gear shift mechanism The gear shift lever is located on the instrument panel. The hollow spherical tip design, paired with a rubber ball joint and preloaded, minimizes loosening of the...

Manual transmission in block with final drive E358
Three-cone synchronization mechanism (1st and 2nd gears) Fig. 3.56. Three-cone synchronization mechanism (1st and 2nd gears) The three-cone synchronization mechanism consists of three locking rings (external, middle and...

Multimodal manual transmission
Fig. 3.59. Block diagram of the multimodal gearbox system In general, the design and operating principle of the multimodal manual transmission installed on the new car model are similar to the units installed on...

Clutch drive — design description
General information Fig. 3.63. Clutch drive The clutch drive consists of the following units: electric motor, clutch travel sensor, worm shaft, worm gear, rod, spring. The drive cannot be disassembled. The rotation of...
There is 1 comment

Gear Shift Lever — Design Description
Gear shift lever Fig. 3.69. Gear shift lever The gear shift lever consists of the following units: gear shift lever position sensor, main gearbox mode switch, gear shift lock solenoid, gear shift lever unit. The...

On-vehicle inspection procedures
Checking the oil level in a manual transmission Stop the car on a level surface. Unscrew the gearbox filler plug and remove the gasket. Fig. 3.79. Checking the oil level in a manual gearbox Make sure that the oil level...

Replacing the front differential seal
Drain the oil. Remove the front wheels. Remove the front left drive shaft assembly. Remove the front right drive shaft assembly. Fig. 3.85. Removing the front cover seal of the main gear housing Using special tool...

Replacing the gear shift lever assembly (C251 / E358)
Fig. 3.89. Gear shift lever parts Disconnecting the gear selection and shift mechanism cables as an assembly Fig. 3.90. Cable tip retainer Remove the retainer and disconnect the gear shift cable end (Fig. 3.90). Fig....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Mechanical gearbox Toyota Corona T190 (1992-1997)
➥ Mechanical gearbox Toyota Cruiser 70 (1985-1996, diesel)
➥ Manual gearbox Toyota RAV 4 XA20 (2000-2005)
➥ Mechanical gearbox Toyota 4Runner N120 (1989-1995)
➥ Manual gearbox Toyota Dyna Y50/Y60 (1984-1995)
➥ Mechanical gearbox Toyota Camry XV10 (1991-1996)

Link in different formats to this article

TEXTHTMLBB Code