Electrical Equipment and Appliances Toyota Corolla 5 (E80)

Installation of additional electrical equipment
After drilling holes in the car body, the sharp edges of the holes must be blunted, primed and painted. The chips formed during drilling must be removed. When working in any way with the electrical equipment of the...

Troubleshooting electrical equipment
Troubleshooting electrical equipment requires time and skill. This applies to identifying the causes of failure of both an incandescent lamp and an electric motor. First of all it is necessary to check the fuse, because...

Checking the relay
The easiest way to check the functionality of the relay is to replace it with a known good one. This is usually done in a specialized workshop. Since a car enthusiast rarely has the necessary new relay available. The...

Checking the windshield wiper motor
The windshield wiper motor is located in the water tank under the windshield. The rear windshield wiper motor is located in the tailgate. To remove the motor, remove the corresponding cover. The front windshield wiper...

Checking the direction indicators and hazard warning lights
The intermittent signal of the direction indicators and hazard warning lights is generated by a relay-interrupter. The direction indicator fuse is separate from the hazard warning light fuse. If the frequency of the...

Checking the brake light
If the brake light does not come on, first check the fuse in the fuse box. If the fuse is OK, check the brake light bulbs. Replace if necessary. If the bulbs are OK, check the brake light switch. The brake light switch...

Checking the rear window heating
After turning on the rear window heating, after some time the glass should be cleared of precipitation and ice. If there are any faults in the heating network, check the fuse first. If the fuse is OK, check the...

Checking the automatic fuse (thermal relay)
The heated rear window, as well as the electric window motor, central locking device and the air conditioning heater fan have automatic fuses that interrupt the power supply circuit if an overload occurs and the cooling...

Replacing fuses
Fuses are used to protect electrical appliances and wires from overload. The TOYOTA car uses fuses with knife contacts. Conventional fuses cannot be replaced. The relays and fuses are located in three mounting blocks...

Removal and installation the instrument panel assembly and replacing lamps
Removal the block Disconnect the ground (-) cable from the battery. Note: This will erase the entries in the trip computer memory. In particular, the fault entry and the radio receiver code. Before disconnecting the...

Removal, disassembly and installation of direction indicator switches, interior lighting and windshield wiper
The direction indicator, interior light and windshield wiper switches are structurally connected to the steering column and are removed as a set. Removal Disconnect the ground (-) cable from the battery. Note: This will...

Removal the radio/loudspeaker
Remove the speaker cover on dashboard . Remove the speaker mounting screws and disconnect the electrical wires. Removal the radio Attention: There are radio receivers with special coding on sale. After installing and...

Location of switches and relays

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Equipment and devices Toyota Dyna Y50/Y60 (1984-1995)
➥ Equipment and devices Toyota Highlander 1 (2000-2007, petrol)
➥ Equipment and devices Toyota 4Runner N120 (1989-1995)
➥ Equipment and devices Toyota Corona T190 (1992-1997)
➥ Equipment and devices Toyota RAV 4 XA10 (1994-2000)
➥ Equipment and devices Toyota Cruiser 100 (1998-2007)

Link in different formats to this article

TEXTHTMLBB Code