Exterior (external elements) of the car Corolla Verso 3 (AR10)

Frontal impact energy absorbing structure
The impact-absorbing body structure of the new Corolla Verso can effectively reduce the effects of a frontal or side impact. By using reinforcements and crossbars that minimize deformation of the passenger compartment,...

Side impact energy absorption structure
Fig. 8.3. Side impact energy absorbing structure To reduce deformation of the passenger compartment, the energy of a side impact is effectively dissipated by the following design elements: external reinforcements of the...

Anti-corrosion body protection
Corrosion resistance is increased by using corrosion-resistant sheet steel, anti-corrosion treatment with wax-containing materials, protective coatings and applying anti-gravel paint coating to parts subject to...

Means for reducing vibration and noise of the body
Effective use of vibration-damping and noise-insulating materials reduces the penetration of engine noise and noise generated by the vehicle's movement into the passenger compartment. Sound-absorbing and...

Front bumper replacement
Note: Installation is performed in the reverse order of disassembly. Only additional points that are important during installation are described. Note: If a bolt does not have a specified torque, refer to the standard...

Replacing the rear bumper
Note: Installation is performed in the reverse order of disassembly. Only additional points that are important during installation are described. Note: If a bolt does not have a specified torque, refer to the standard...

Replacing the rear window seal of the front left door
Note: Installation is performed in the reverse order of disassembly. The sequence of actions is the same for the right and left sides of the car. Note: If a bolt does not have a specified torque value, refer to the...

Removal and installation the windshield
Removal Fig. 8.23. Windshield seal cutting lines Note: To avoid damaging the glass, proceed as follows: cut the seal with a knife along the lines shown in Figure 8.23. Remove the remaining part of the seal with your...

Adjusting the hood
Note: Centering bolts are used to secure the hood hinges and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. When adjusting, the centering bolts should be replaced with standard...

Front door adjustment
Note: Before adjusting the door position on vehicles equipped with side airbags and curtain airbags, disconnect the negative (–) terminal from the battery terminal. After adjustment, check the operation of the...

Adjusting the trunk door
Note: Centering bolts are used to secure the hood hinges and hood latch. The hood and hood latch cannot be adjusted with the centering bolts installed. When adjusting, the centering bolts should be replaced with...

Nominal tightening torques
Table 8.1. Nominal tightening torques for external and internal finishing elements Table 8.2. Nominal tightening torques (hood / door) Table 8.3. Nominal tightening torques (seats) Table 8.4. Nominal tightening torques...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Exterior (external elements) Toyota RAV 4 XA10 (1994-2000)
➥ Exterior (external elements) Toyota Carina T190 (1992-1996)
➥ Exterior (external elements) Toyota Cruiser 100 (1998-2007)
➥ Exterior (external elements) Toyota 4Runner N120 (1989-1995)
➥ Exterior (external elements) Toyota Camry XV20 (1996-2001)
➥ Exterior (external elements) Toyota Highlander 1 (2000-2007, petrol)

Link in different formats to this article

TEXTHTMLBB Code