Car engine power system Toyota Corolla 5 (E80)

The fuel supply system includes a fuel tank with a fuel level sensor, fuel lines and hoses, a fuel filter, a fuel pump and a carburetor or injection system with an air filter.

Requirements for cleanliness when caring for the power supply system
When working with the power supply system, it is necessary to strictly adhere to the following rules: Thoroughly clean joints and surrounding areas before disassembling; Place the removed parts on clean trays and cover...

Checking the fuel level sensor
The fuel level sensor is located at the top of the fuel tank. As the fuel level drops, the sensor float drops. At the same time, the electrical resistance of the variable resistor connected to the float increases. As a...

Removal and installation the fuel tank and fuel level sensor
The fuel tank capacity is about 50 liters. The tank is made of sheet steel and is installed in the area of the rear suspension. Removal Warning: Fuel may leak when removing the fuel tank. Particularly dangerous are...

Removal and installation the fuel pump (injector)
The fuel pump is located in the fuel tank. Warning: Fuel may leak when removing the fuel pump. Particularly dangerous are gasoline vapors, which can cause fire and poisoning. Therefore, it is necessary to pay special...

Removal, installation and testing of the fuel pump (carburetor)
The fuel pump is mounted on the cylinder head. It is driven via a lever directly from the camshaft. To check the pump, it must be removed. Warning: Fuel may leak when removing the fuel pump. Particularly dangerous are...

Removal and installation the air filter (carburetor)
Removal Loosen the clamps securing the suction hose to the air filter housing cover. Remove the vacuum hoses from the suction system and the thermal vacuum valve. Remove the clamps and wing nut. Remove the air filter...

Removal and installation the air filter (injector and diesel)
Removal Open the latches and remove the air filter cover. Remove the filter element. If there is an intake air temperature sensor, remove it from the air filter housing. Loosen the screw securing the suction hose clamp...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Fuel system Toyota 4Runner N120 (1989-1995)
➥ Fuel system Toyota Cruiser 70 (1985-1996, diesel)
➥ Fuel system (petrol) Toyota RAV 4 XA20 (2000-2005)
➥ Fuel system Toyota Carina T190 (1992-1996)
➥ Fuel system Toyota Camry XV20 (1996-2001)
➥ Supply and exhaust system Toyota Highlander 1 (2000-2007, petrol)

Link in different formats to this article

TEXTHTMLBB Code