Car rear suspension Toyota Corolla 5 (E80)

Description and structure of the rear suspension
TOYOTA COROLLA cars are equipped with rear suspension of different designs. In front-wheel drive models, each rear wheel has independent shock absorbers, two transverse suspension arms and a longitudinal rod. Both...

Removal and installation the rear shock absorber strut
Removal Limousine (sedan). Remove the hat hanger and air duct to track access to the upper shock absorber support. Liftback (combi). Disconnect the speaker grille from the top of the shock absorber in the area of the...

Disassembling the rear shock absorber. Removing and installing the shock absorber and coil spring
Removal Remove the rear pillar, see previous section . To remove the shock absorber, you must first compress the spring. In workshops, special devices are used for this. Caution: Never remove the shock absorber unless...

Rear wheel hub and suspension bracket
Note: If the wishbones or trailing arm are disconnected, the silent blocks must be lifted if the vehicle is on its wheels. After assembly, geometric measurements of the vehicle's chassis must be taken.

Checking wheel hub bearings
Installing the hub Signs of a damaged rear wheel bearing include extraneous noise that occurs when the speed reaches a certain value. The rear wheel bearings consist of two high-precision ball bearings. The bearing is...

Removal and installation shock absorber and coil spring Toyota Corolla Tercel 4WD
The rear axle of the all-wheel drive TOYOTA COROLLA TERCEL has independent shock absorber struts in the form of coil springs with shock absorbers inside them. To remove the coil springs, you must first remove the shock...

Rear suspension control parameters
Rear suspension control parameters 1) The deviation of the right wheel from the left is no more than 30' 2) For a car with an engine capacity of 116/121 hp -41'±45'

Rear wheel adjustment
Rear wheel alignment, only cars up to 4.87 If the camber is outside the permissible limits, it should be adjusted by rotating the adjusting cam. To do this, loosen the upper nut securing the shock absorber in the...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Rear suspension Toyota Carina T170 (1988-1992)
➥ Rear suspension Toyota Corona T190 (1992-1997)
➥ Rear suspension Toyota Camry Vista V40 (1994-1998)
➥ Rear suspension Toyota RAV 4 XA20 (2000-2005)

Link in different formats to this article

TEXTHTMLBB Code