Vehicle ignition system Toyota Corolla 5 (E80)

General description of the ignition system
The engine ignition system produces a spark that ignites the fuel-air mixture entering the combustion chamber of the cylinder. To ensure that the ignition spark is powerful enough, the 12 V battery voltage is converted...

Safety precautions when working with the ignition system
The voltage in the ignition systems of TOYOTA COROLLA cars can reach 30 kV. Under unfavorable conditions, for example, if there is moisture in the engine compartment, a breakdown of the insulation of high-voltage wires...

Electronic ignition system (ESA)
Engine capacity 1.3 l

Checking, removing and installing the ignition coil
Note: The test is carried out in the following sequence. Remove the distributor cap. Turn on the ignition. Checking the primary winding of the coil Measure the resistance between the positive (+) and negative (-)...

Checking the ignition cable
Excessive resistance in the ignition cables causes difficulty starting the engine and interruptions in the operation of the ignition system. Disconnect the ground (-) cable from the battery. Warning: This will erase the...

Replacing breaker contacts
Only for engines with a working volume of 1.3 l up to 7/84 of production (uKZ system). During operation, the contacts of the breaker wear out, visible signs of this are build-ups and craters. In addition, the plastic...

Checking and adjusting the angle of the closed state of contacts
Only for engines with a working volume of 1.3 l (contact ignition system (UKZ) To adjust the breaker contacts, specialized workshops use a special measuring device. The advantage of this device is the ability to...

Checking and adjusting the ignition timing
For engines with a contact ignition system, it is necessary to check the ignition timing after adjusting the angle of the closed state of the breaker contacts and, if necessary, adjust it. Similar checks and adjustments...

Removal and installation the ignition distributor
The ignition distributor is driven by the camshaft. It is mounted on the cylinder head on the flywheel side. Removal Disconnect the ground (-) cable from the battery. Warning: This will erase the on-board computer...

Spark plugs — general information
Spark plugs consist of a central electrode, an insulator with a housing and a side electrode (ground electrode). The central electrode is installed in the insulator, the insulator is firmly connected to the housing. A...

Spark plugs recommended for use in Corolla vehicles
Note: Due to constant changes, engines of the same power may be equipped with ignition systems that differ in design. Therefore, it is recommended to check which spark plugs are installed in a given engine and which are...

Ignition system malfunctions
Ignition system malfunctions Malfunction: The engine starts poorly or does not start at all. 1) This fault can only occur in contact ignition systems. 2) This malfunction can only occur in built-in and electronic...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Ignition system Toyota Carina T170 (1988-1992)
➥ Ignition system Toyota 4Runner N120 (1989-1995)
➥ Ignition system Toyota Dyna Y50/Y60 (1984-1995)
➥ Ignition system Toyota RAV 4 XA10 (1994-2000)
➥ Ignition system Toyota Corona T190 (1992-1997)

Link in different formats to this article

TEXTHTMLBB Code