For cars with ABS | 
For cars without ABS |
2. Install the pistons.
Caution: Be careful not to damage the cuffs.
- a) Install the pistons strictly along the axis without distortions.
Caution: If the piston is installed at an angle, the cylinder bore may be damaged.
- b) Press the piston with a screwdriver and install the retaining ring.
Note: Wrap the screwdriver with electrical tape before use.
3. Using a screwdriver, push the pistons through their full stroke and install the lock bolt with a new gasket. Tighten the bolt. Tightening torque is 10 Nm.
4. Install two rubber bushings.
5. Install the tank.
- a) Install the mesh filter and cover.
- b) Install the tank and secure it with a screw. Tightening torque 1.7 Nm.
6. Install the dust boot onto the master cylinder with the mark facing up, as shown in the figure.
