Removal and installation
Note:
- Removal is carried out in accordance with the relevant figure "Removing the brake master cylinder".
- Install in the reverse order of removal.
- The tightening torques are indicated in the text.
- After installation, perform the following operations:
- A) Fill the reservoir with brake fluid and bleed the brake system.
- b) Check for leaks.
- V) Check and adjust the brake pedal.
Disassembly and assembly
Note:
- Carry out disassembly in accordance with the figure "Master brake cylinder".
- Reassemble in the reverse order of disassembly.
- When assembling, apply special grease to the indicated surfaces.
Master brake cylinder.
1 - cuff,
2 - a bolt of fastening of a tank,
3 - tank assembly,
4 - bushing,
5 - pin,
6 - retaining ring,
7 - piston seal,
8 - piston No. 1,
9 - piston number 2.
Note: When assembling, apply special grease to the surfaces indicated by the arrows.
Removing the brake master cylinder.
1 - brake pipes,
2 - master brake cylinder,
3 - gasket,
4 - fastening bolt,
5 - seal (since 2000).