Replacing the hub bolt [Toyota Corona T190]

1. Jack up the car, remove the front wheel.

2. Remove the caliper assembly and brake disc.

3. Using a special tool, unscrew the hub bolt.

4. Install the hub bolt.

a) Install the washer and nut onto the hub bolt as shown in the figure.

b) Tighten the nut and install the bolt.

5. Install the brake disc and caliper assembly. Tightening torque 94 Nm.

6. Install the front wheel and lower the vehicle. Tightening torque 103 Nm.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Corona T190: Front suspension

Next ▶

Installing the steering knuckle with the hub
Front axle hub assembly
Disassembling the front axle hub
Removal the steering knuckle with the hub
Front Axle Hub — Design Description

Front suspension strut — design description
Removal the front suspension strut
Assembly and installation of the front suspension strut
Lower control arm of the front suspension — description of the design
Removal the lower arm