- A) Install the steering knuckle and temporarily install the two bolts.
Note: Apply engine oil to the nut threads.
- b) Connect the lower ball bolt and two nuts. Tightening torque 127 Nm.
2. Connect the tie rod end.
- A) Connect the tie rod end to the steering knuckle and tighten the nut. Tightening torque 49 Nm.
- b) Install a new pin.
3. Tighten the bolts on the underside of the shock strut. Tightening torque 275 Nm.
4 (For vehicles with ABS) Install the speed sensor (ABS). Tightening torque 7.8 Nm.
5. Install the caliper assembly.
- A) Install the brake disc.
- b) Install the caliper assembly. Tightening torque 94 Nm.
6. Install the drive shaft locknut.
- A) Install the nut and tighten it with the brake pedal depressed. Tightening torque 226 Nm.
- b) Install locknut cap and new cotter pin.
7. Install the front wheel and lower the vehicle. Tightening torque 103 Nm.
8. Check up corners of installation of forward wheels.