Note: The headlight and turn signal switch operates regardless of the position of the key in the ignition switch.
a) When you turn the knob to the first click (ON1), the side lights, license plate light and instrument cluster light are turned on.
b) When you turn the knob to the second click (ON₂), the low beam headlights are turned on.
2. To turn on the high beam headlights, press the switch away from you when the switch handle is in the "ON₂" position. The operation of the high beam headlights is accompanied by the corresponding indicator on the instrument cluster.
To turn off the high beam headlights and turn on the low beam headlights, move the switch to its original position (towards you).
3. To briefly turn on the high beam headlights (high beam headlight alarm) pull the lever towards you until it stops, then release the lever. The system works even if the switch handle is in the "OFF" position.
4. To turn on the turn signal, move the lever up or down (position 1). The corresponding turn signal indicator on the instrument cluster flashes. The lever will automatically return to its original position after the turn is completed. However, when changing lanes, you may need to manually return the lever to the neutral position.
[The original can be viewed on the website: TOYOTAMAN.ru]
To activate the lane change signal, move the lever to the up or down position until resistance is felt and hold it in this position (position 2).
Caution: If the turn signal indicators on the instrument cluster flash more frequently than usual, the front or rear turn signal bulb has burned out.
5. The front fog lights operate only when the headlight switch knob is in the (ON1) or (ON₂) position.
To turn on the front fog lights, press the switch shown in the figure.
6. The hazard warning lights are activated by pressing the switch located as shown in the figure.
