Note: The headlight and turn signal switch operates independently of the ignition switch.
A) When the knob is turned to the first click, the dimensions, license plate light and instrument panel light are turned on.
b) When the knob is turned to the second click, the low beam headlights are switched on.
Attention: To avoid discharging the battery, do not leave the headlights on for a long period of time when the engine is off.
2. To turn on the high beam headlights, turn the switch to the position as shown in the figure (Push). The operation of high beam headlights is accompanied by the illumination of the corresponding indicator on the instrument cluster. To turn off the high beam headlights and turn on the low beam headlights, move the switch to its original position (to myself).
For short-term switching on of high beam headlights (high beam alarm) pull the lever towards you as far as it will go, then release the lever.
(Modifications) To turn on the auxiliary lighting system, you must move the headlight switch to the position "AUTO", as it shown on the picture. This system turns on additional lighting when the illumination decreases (tunnel entrance, dusk, etc.), when turning the vehicle and only works when the headlights are on.
When the engine is stopped, when the headlights are switched to the "AUTO", and when the driver's door is opened, the headlights will automatically go out. With the ignition key in position "ON" headlights are lit.
Note: Do not place any objects on the auto headlight sensor. The location of the sensor is shown in the figure.
3. Move the lever up or down to turn on the turn signal. The lever will automatically return to its original position after the turn is completed. However, when changing lanes, it may be necessary to manually return the lever to neutral.
To turn on the lane change signal, move the lever up or down until there is resistance to movement and set it in this position.
Caution: If the turn signal indicators on the instrument cluster flash faster than usual, the front or rear turn signal lamp is burned out.
4. To turn on the fog lights, you must move the switch to the position shown in the figure.
The fog lights only work when the headlight switch is in the ON1 or ON2 position.
5. The alarm is activated by pressing the button located as shown in the figure.