a) Fix the Seal to the glass.
Warning: If the sealing conditions are not met when installing the old seal, install a new seal.
b) Wet the contact surfaces with soapy water.
c) Using "A" as a fulcrum, insert the corner glass into place.
2. Apply grease before installing each part as shown in the figure.
3. Install the outside door handle.
4. Install the door lock and tighten the screws.
5. Install the door lock cylinder.
6. Install the window lift mechanism through the service hole and tighten with three bolts.
7. Place the door glass into the groove and insert it into the mechanism.
8. Install the divider strip on the door, tighten the screw and two bolts, then insert the door glass frame into the strip.
Note: Wet the door glass frame with soapy water.
9. Install the inner and outer seal.
a) Install four clips onto the door panel and outer weatherstrip.
b) Install four clips onto the inner seal and insert the seal into the door panel.
10. Install the service hole cover.
a) Apply sealant to the service hole cover and insert the bottom of the cover into the door panel slot. Seal the panel slot with adhesive tape.
Warning: Do not tape over the panel holes for the door panel clips.
Note: Install the service hole cover after installing the door lock rod.
11. Install the door lock rod.
12. Install the interior door trim panel.
The original version is published on the website (www.ToyotaMAN.ru)
13. Install the decorative door handle cover.
a) Connect the rod to the handle, insert the trim into the door panel, slide it forward and tighten the screw.
14. Install the window lift handle when the door window is completely closed and secure it with the locking ring as shown in the figure.
15. Install the inside door closing handle.