a) Loosen the screw, press the cover as shown in the figure and detach it.
2. Remove the window lift handle by removing the retaining ring with a piece of cloth.
3. Remove the inside door closing handle.
4. Remove the inner door trim panel.
a) Insert the screwdriver as shown in the figure and separate the panel.
Note: Wrap the screwdriver with electrical tape before use.
5. Remove the service hole cover.
6. Remove the door lock rod.
7. Remove the inner and outer glass seal.
a) Using a scraper, pry up the inner seal and remove it with the four clips.
Note: Wrap the scraper with electrical tape before use.
b) Using a scraper, pry up the clamp and remove the outer seal.
Components of the front door:
1 - Door glass frame,
2 - Door glass,
3 - Rubber insert,
4 - Glass holder,
5 - External door handle,
6 - Door lock button,
7 - Door lock cylinder,
8 - Door lock,
9 - Door lock retainer,
10 - Door lock rod,
11 - Window lifting mechanism,
12 - External glass seal,
13 - Internal glass seal,
14 - Internal door closing handle,
15 - Decorative cover for the inner door opening handle,
16 - Window lifter handle,
17 - Interior door trim panel,
18 - Service hole cover,
19 - Loop,
20 - Door travel limiter,
21 - Corner glass seal,
22 - Corner window glass,
23 - Dividing bar.
Note: Wrap the scraper with electrical tape before use.
c) Turn the clamp 90° and remove it.
8. Remove the divider bar.
a) Unscrew the screw and two bolts.
b) Remove the door glass frame from the partition strip.
b) Remove the divider strip from the window.
9. Separate the door glass from the window lifting mechanism and remove it.
10. Remove the window lift mechanism.
a) Unscrew the three bolts and remove the mechanism through the service hole.
11. Remove the door lock retainer and cylinder.
12. Unscrew the three screws and remove the door lock through the service hole.
13. Unscrew the two bolts and remove the outer door handle.
14. Remove the corner window glass.
a) When reusing the seal: turn the door glass slightly in the direction shown in the figure and carefully remove the glass.
b) If the seal is not reused: cut the seal from the outside with a knife, press on the glass from inside the machine and remove it. Remove the seal.
