Car breakers and switches Toyota Carina 6 (T190)

Combination switch device
1 - clamp, 2 - clamp, 3 - lighting control switch, 4 - high/low beam headlight switch, 5 - ball, 6 - finger, 7 - retainer plate, 8 - turn signal switch assembly, 9 - direction indicator switch.

Removal and installation the lighting control switch
1. Remove the turn signal switch assembly. 2. Remove the clamp. 3. Removing the lighting control switch. a) Unscrew the two screws. b) Set the switch to the Hi position and remove the locking plate. c) Remove the switch...

Removal and installation the high/low beam switch
1. Remove the turn signal switch assembly. 2. Remove the clamp. 3. Removing the high/low beam switch. Type 1 a) Disconnect the light control switch wiring harness from the clamp. b) Remove the two screws and remove the...

Removal and installation the turn signal switch
1. Remove the turn signal switch assembly. 2. Remove the clamp. 3. Removing the turn signal switch. a) Bend back the three clips and remove the turn signal switch. b) Remove the connector retainer. c) Bend back the...

Automatic headlight and side light switching system
1. Checking automatic switching on. a) Turn on the ignition. b) Set the lighting control switch to the "AUTO" position. c) Close the light access to the light sensor and make sure that the lamps light up in the order...

Checking the combination switch
Checking the Light Control Switch Checking the high/low beam switch

Checking the fog light switch
Check that there is continuity between terminals "EF" and "FG" if the switch is in the "ON" position, and that there is no continuity between terminals "EF" and "FG" if the switch is in the "OFF" position. Checking the...

Checking the turn signal relay

Checking the hazard warning switch
Check that there is conductivity between terminals "T" and "E1" in any position of the switch. Check that there is continuity between terminals "B1" and "F" if the switch is in the "OFF" position, Check that there is...

Checking the reverse light switch (manual transmission)
Check for conductivity between terminals "1" and "2" when pressing the switch ball.

Checking the start inhibit switch and the automatic transmission selector position sensor
Check the conductivity between the connector terminals at different selector positions.

Checking limit switches
Check that there is no continuity between the connector terminal and the bracket when pressing the switch rod.

Checking the glove compartment light limit switch
Check that when you press the switch rod, there is no conductivity between terminals "1" and "2" of the connector.

Checking the brake light switch
Continuity between terminals "1" and "2" when pressing the brake pedal.

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Link in different formats to this article

TEXTHTMLBB Code