Checking and adjusting thermal clearances in valves Note: checking and adjusting the thermal clearances in the valves is carried out on a cold engine. 1. Disconnect the negative plug from the storage battery. 2. Disconnect the wiring harness. 3. Disconnect the crankcase...
Timing belt device (A series engines) 1 - high voltage wires, 2 - power steering pump drive belt, 3 - coolant pump pulley, 4 - wiring harness protection, 5 - wiring harness, 6 - washer tank, 7 - right engine support, 8 - oil filler cap, 9 - hoses of the...
Removing the timing belt 1. Disconnect the negative plug from the storage battery. 2. Remove the right side of the engine protection. 3. Loosen the coolant pump pulley bolt. 4. Remove the alternator drive belt. A) Loosen the pinch bolt. b) Turn...
Timing belt installation Note: Keep water or oil away from the camshaft and crankshaft pulleys and keep them clean. 1. Install the camshaft sprocket (if it was taken). A) Align the dowel pin on the nose of the camshaft with the groove of the...
Removing the cylinder head 1. Disconnect the wire from the negative battery terminal. 2. Drain the coolant. 3. Remove the timing belt (see section "timing belt"). 4. (5A-FE, 7A-FE) Remove the integrated ignition assembly. 5. (4A-FE) Remove the...
Cylinder head device (A series engines) 1 - power steering pump, 2 - distributor (4A-FE) or combined ignition unit (5A-FE, 7A-FE), 3 - air filter cover with air duct, 4 - cover No. 1 of the camshaft bearing, 5 - cover No. 2 of the camshaft bearing, 6 - cover...
Installing the cylinder head 1. Install the cylinder head. A) Install a new cylinder head gasket, taking into account the position of the guides on the block. b) Lower the cylinder head onto the gasket. Note: Before installing, apply a light coat...
Preparation for disassembly of the cylinder block 1. (Models with manual transmission) A) Remove the clutch cover and clutch disc. b) Remove flywheel by removing 6 bolts. Note: before removing the flywheel or torque converter drive plate, set marks so as not to disturb...
Final assembly of the cylinder block 1. Install the oil pump (see chapter " Lubrication system "). 2. Install the oil pan and oil receiver with strainer (see chapter " Lubrication system "). 3. Install the knock sensor using a suitable tool. 4. Install the...