Engines 3S-FE, 4S-FE car Toyota Carina 6 (T190)

Checking and adjusting thermal clearances in valves
Note: Check and adjust the valve clearance on a cold engine. 1. Disconnect the negative terminal from the battery. 2. Disconnect the wiring harness. 3. Disconnect the accelerator cable. 4. Disconnect the throttle valve...

Removal the timing belt
1. Disconnect the negative terminal from the battery. 2. Remove the right side of the engine guard. 3. Remove the generator drive belt. 4. Remove the power steering pump drive belt. 5. Remove the right engine support by...

Installing the timing belt
1. Install the oil pump pulley. (If it was filmed). a) Align the pulley and shaft profiles and install the pulley. b) Tighten the oil pump pulley mounting nut. Tightening torque - 28 Nm 2. Install the crankshaft timing...

Timing belt (3S-FE, 4S-FE) — device
1 - timing belt, 2 - gasket, 3 - timing belt cover No.2, 4 - timing belt cover No.1, 5 - right engine support, 6 - shock absorber of the right engine support, 7 - power steering pump drive belt, 8 - crankshaft pulley, 9...

Removal the cylinder head
See also chapter " Fuel injection system ". 1. Disconnect the negative terminal from the battery. 2. Drain the coolant from the engine. 3. Remove the timing belt (see section " Timing belt "). 4. Remove the distributor...

Cylinder head (3S-FE, 4S-FE) — installation
1 - cylinder head cover, 2 - crankcase ventilation hose, 3 - gasket, 4 - bearing cover No.1 of the camshaft, 5 - bearing cover No.2 of the camshaft, 6 - air filter cover with air duct, 7 - accelerator cable bracket, 8 -...

Installing the cylinder head
1. Install the cylinder head onto the cylinder block, after installing a new cylinder head gasket. 2. Install the cylinder head mounting bolts. Note: - The cylinder head mounting bolts are tightened in two stages. - If...

Operations before disassembling the cylinder block
1. Remove the flywheel (models with manual transmission) or torque converter drive plate (models with automatic transmission). Note: Before removing the flywheel or torque converter drive plate, mark them to avoid...

Final assembly of the cylinder block
1. Install the knock sensor. Tightening torque - 37 Nm 2. Install the oil filter. 3. Install the coolant pump. a) Install a new O-ring on the coolant pump cover. c) Install the adjustment bracket by tightening the bolt....

Cylinder block structure
Cylinder block, parts for disassembly and assembly: 1 - drain plug, 2 - gasket, 3 - oil pan, 4 - oil receiver, 5 - oil depressant, 6 - front crankshaft oil seal, 7 - main bearing, 8 - crankshaft, 9 - generator drive...

Flywheel and torque converter drive plate design (S series engines)
1 - flywheel assembly, 2 - clutch disc, 3 - clutch basket, 4 - manual transmission, 5 - oil seal, 6 - front spacer sleeve, 7 - torque converter drive plate, 8 - rear spacer sleeve, 9 - automatic transmission.

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Petrol engine 3S-FE Toyota RAV 4 XA10 (1994-2000)

Link in different formats to this article

TEXTHTMLBB Code