Steering wheel play check With the vehicle stationary, with the wheels in the straight ahead position, move the steering wheel from side to side with a little effort. If the play exceeds the allowable value, repair. Maximum backlash - 30 mm
Checking the booster pump drive belt Press the belt with a force of 98 N, and measure the deflection of the belt. Drive Belt Deflection: 4A-FE, 5A-FE: new - 5-6 mm used - 6-8 mm 1 - power steering pump pulley, 2 - coolant pump pulley, 3 - roller tensioner,...
Checking the fluid level 1. Install the car on a horizontal platform. 2. With the engine off, check the fluid level and top up if necessary. Working fluid - ATF DEXRON ® II or III Note: if the working fluid is warmed up, the fluid level is in...
Steering wheel force check Note: Before checking, check the tire pressure, tire type and tire contact surface. 1. (For models not equipped with an airbag) Remove the steering wheel cover. A) Loosen the steering wheel cover bolt and remove it. b)...
Power steering fluid pressure test 1. Connect a pressure gauge. (4A-FE, 5A-FE, 2C) A) Unscrew the nipple bolt and remove the gasket. Tightening torque - 52 Nm (3S-FE, 4S-FE) A) Using the special tool, disconnect the discharge line from the pump housing....
Bleeding the power steering system 1. Check the fluid level in the reservoir. 2. Raise the front of the vehicle and place it on stands. Note: Be careful not to splash liquid out of the reservoir. 3. With the engine off, turn the steering wheel from lock...
Steering gear — removal and installation Removing 1. Remove the front wheel. Tightening torque - 105 Nm 2. Drain the power steering fluid. 3. Install the engine support. 4. Disconnect the tie rod ends from the steering knuckle arms. A) Remove cotter pins and...
Steering rod replacement 1. Disconnect the tie rod ends from the steering knuckle arms. 2. Loosen the locknut and remove the tie rod end. 3. Remove steering draft. A) Loosen the clamps and remove the tie rod cover. Attention: - be careful not...
Power steering pump (4A-FE, 5A-FE, 7A-FE) — removal and installation Removing 1. Remove the lower right engine guard. 2. Disconnect vacuum tubes from the valve of increase in frequency of rotation of idling. 3. Drain the power steering fluid. 4. Turn away a union bolt, remove a lining...
Power steering pump (3S-FE, 4S-FE) — removal and installation Removing 1. Remove the right front wheel. Tightening torque - 105 Nm 2. Remove the lower right engine protection cover. 3. Disconnect the right tie rod end from the steering knuckle arm. A) Remove the cotter pin and...
Power steering pump (2C) — removal and installation Removing 1. Drain the power steering fluid. 2. Remove the expansion tank. 3. Disconnect the connector, unscrew the two bolts and remove the washer reservoir. 4. Loosen the tensioner pulley bolt and remove the drive...
Steering column device Tilt steering column 1, 7 - doggy, 2, 6 - sleeve, 3 - the upper tube of the steering column, 4, 15 - retaining ring, 5 - combination switch bracket, 8, 10 - dog retainer, 9 - lever for adjusting the angle of...
Steering column — removal and installation Removing 1. Remove the steering wheel pad A) Loosen the bolt. b) Remove the trim and disconnect the connector. (For vehicles equipped with an airbag) Remove the steering wheel cover. Attention: store the steering wheel...