Checking the glove compartment light limit switch [Toyota Carina T190]
Check that when you press the switch rod, there is no conductivity between terminals "1" and "2" of the connector.
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
The article material has been checked: Kondratyeva Ulyana
Share information:
Similar articles on other Toyota models
➥ Reverse Light Switch — Checking and Replacing Toyota Camry XV20 (1996-2001)
➥ Checking the brake light switch Toyota Corona T190 (1992-1997)
➥ Checking and replacing the brake light switch sensor Toyota Cruiser 100 (1998-2007)
➥ Brake Light Switch — Checking and Replacing Toyota 4Runner N120 (1989-1995)
➥ Checking and replacing the reverse light switch Toyota RAV 4 XA10 (1994-2000)
➥ Rear fog light switch Toyota Corolla E80 (1983-1990)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Maintenance
- Power unit
- Engines 4A-FE, 5A-FE, 7A-FE
- Engines 3S-FE, 4S-FE
- Diesel engines 2C
- Engine repair
- Cooling system
- Lubrication system
- Fuel system
- Control system (diesel)
- Fuel injection system
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis, running gear
- Car suspension
- Steering
- Brake system
- Body and interior
- Exterior (external elements)
- Interior (internal elements)
- Air conditioning and heater
- Electrical equipment
- Equipment and devices
- Headlights and lighting
- Breakers and switches
- Electrical circuits
- General information
- Introduction to the manual
- Power unit
- Gasoline engines
- Diesel engines
- Lubrication system
- Cooling system
- Fuel system (carburetor)
- Fuel system (injector)
- Ignition system
- Transmission
- Clutch
- Car gearbox
- Drive shafts
- Chassis, running gear
- Front suspension
- Rear suspension
- Steering
- Brake system
- Electrical equipment
- Power devices
- Electrical circuits