Engine lubrication system The engine has a circulating lubrication system. The oil pump is mounted on the crankshaft, behind the crankshaft pulley. The oil pump housing is also the front oil seal housing. Pumps on different engines have...
Replacing the oil pan gasket (Removing and installing the oil pan) The oil pan can be removed without removing the engine. After unscrewing the drain plug and draining the engine oil, removing the oil pan is not difficult. If necessary, you can...
Oil pump — 1.6 l engine (4A-F/FE) The oil pump parts are shown in Figure 113. All details for removal and installation can be seen from this figure. Pic. 113. Installation drawing of a tin pump for a 1.6 liter engine. 1. Oil dipstick; 2. Oil pump...
Oil Pump — 2.0L Engine (3S-FE) Pic. 116. Location of the oil pump on the 2.0 l engine Removing and installing the oil pump As on the 1.6 liter engine, to remove the oil pump the oil pan and oil intake screen must be removed. A conventional...
Oil filter The oil filter is located on the side of the engine under the ignition wires. The filter cartridge is unscrewed using a special wrench, which can be purchased at auto parts stores. If there is no such key and you need...
Checking the engine oil level Check the oil level after placing the vehicle on level ground. If the engine was running before, stop it to allow the oil to drain into the oil pan. Pull out the oil dipstick and wipe it with a cloth. Insert the...
Sizing and Adjustment Charts — Engine Lubrication System Lubrication system pressure: 16 valve engines at 3000 rpm - 2.5-5.0 kg/cm 2 minimum pressure at idle - 0.3 kg/cm 2 diesel engine at 3000 rpm —— 2.5-3.0 kGy/cm 2 minimum pressure at idle - 0.5 kg/cm 2 Engine oil filling...