Vehicle fuel system (carburetor) Toyota Carina 5 (T170)

Carburetor — all engines
The 4A-F/FE 1.6L engine works with either a mechanical carburetor with sequential switching of the mixing chambers or with a similar carburetor, but with electronic control. The data below is given for the mechanical...

Carburetor adjustments
Float level The float level should be checked in the raised (upper) and lowered (lower) state. For the first check, a piece of steel rod can be used. For the second check, a set of feeler gauges from 1.67 to 1.99 mm is...

Fuel pump
5.3.1. Removal and installation Disconnect the hoses and wires from the pump. Loosen the pump nuts. Remove the pump with the intermediate flange and gaskets from the cylinder head. The pump is installed in the reverse...

Air filter
The air filter should be replaced under normal operating conditions after 30,000 km. In conditions of increased dust, more frequent replacement is required. The filter element can be cleaned to a certain extent by...

Positive crankcase ventilation
With the help of this device, gases breaking through into the crankcase are returned through the intake manifold and air filter. To return gases from the crankcase to the intake manifold, a valve is included in the...

Tables of sizes and adjustments — fuel system — carburetor
Carburetor - Two-stage falling-draft carburetor Float level: in the raised position - 7.2 mm in the lowered position - 1.67 - 1.99 mm The basic setting of the mixture adjustment screw is 3 turns out Idle speed - 800 rpm...

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Fuel supply (carburetor) Toyota Corolla E80 (1983-1990)
➥ Fuel system (carburetor) Toyota Cruiser 60/80 (1980-1997, petrol)

Link in different formats to this article

TEXTHTMLBB Code