2. Remove the clamp.
3. Removing the high/low beam switch.
Type 1
a) Disconnect the light control switch wiring harness from the clamp.
b) Remove the two screws and remove the high/low beam switch.
c) Remove the connector retainer.
d) Bend back the clips, remove the wires and finally remove the high/low beam headlight switch.
Type 2
a) Disconnect the light control switch wiring harness from the clamp.
b) Remove the four screws and remove the high/low beam switch.
c) Remove the connector retainer.
d) Bend back the clips, remove the wires and finally remove the high/low beam headlight switch.
4. Install in the reverse order of removal.
Note: Do not mix up the colors of the wires being connected.
Type 1
Type 2
The original is this website ToyotaMAN