Removal the steering gear: 1 - gasket, 2 - inlet pipe, 3 - clamp, 4 - engine mount central support beam, 5 - cross beam, 6 - pipe clamp bracket, 7 - discharge pipe, 8 - return hose, 9 - intermediate shaft No.2, 10 - bracket, 11 - clamp, 12 - bushing, 13 - steering gear, 14 - cotter pin, 15, 19 - plug, 16 - engine mount central support beam protection, 17 - exhaust gas temperature sensor, 18 - lower engine protection, 20 - spring
Install in the reverse order of removal.
1. Set the wheels in the direction for straight driving. Remove the steering wheel cover.
2. Remove the steering wheel.
3. Remove the lower engine guard. 4. Disconnect the steering rod ends.
5. Remove the exhaust pipe.
- a) Disconnect the oxygen sensor connector.
- b) Unscrew the two bolts and remove the exhaust gas temperature sensor and gasket.
- c) Unscrew the two bolts and remove the two springs and gasket.
- d) Unscrew the two bolts securing the intake pipe bracket.
- d) Unscrew two bolts, two nuts and remove the gasket and the inlet pipe.
(The article was copied from the portal: «TOYOTAMAN»)
6. Disconnect intermediate shaft No.2.
7. Using a special tool, disconnect the pipes.
8. Loosen the bolt and disconnect the tube clamp bracket.
9. Raise the engine.
10. Disconnect the lower ball joint from the lower arm on both sides.
11 Loosen the bolt and disconnect the tube clamp bracket.
12. Remove the cross and center engine mount beams.
13. Remove the steering gear.
14. Remove the brackets and bushings.