2. If necessary, replace the ignition lock cylinder.
- A) Set the ignition key to position "ACC".
- b) Press the locking pin with a thin rod and remove the lock cylinder.
- V) Make sure the ignition key is set to "ACC".
- G) Install a new ignition lock cylinder.
3. Check up contact group of the lock of ignition.
4. Check up the sensor of the key left in the ignition lock.
5. If necessary, replace the contact group of the ignition switch with the sensor of the key left in the ignition switch.
- V) Remove the two screws from the ignition lock bracket.
- b) Remove the ignition lock cylinder
- G) Remove the contact group.
- V) Install a new contact group and tighten the two screws.
6. Check that the bearing rotates smoothly, without binding or extraneous noise.
If the bearing is worn or damaged, replace the steering column tube.