Volume control
The volume is adjusted when the slider 1 is in the extended position (for this you need to click on it).
Balance adjustment
The balance of the right and left channels is adjusted by knob 11 "BAL/FADE" in half pressed position (one push on the handle).
The balance between the front and rear speakers is adjusted by knob 11 "BAL/FADE" in fully retracted position (press the handle again).
Equalizer
By pressing button 13 "ACS" equalizer settings for standard music programs are selected.
Mode | Setting |
CLASSIC | equalizer disabled |
ROCK | bass and treble boost |
POPS | high frequency boost |
JAZZ | bass and treble boost |
VOCAL | midrange boost |
DEFEAT | manual tone control mode |
Manual tone control
Manual adjustment is possible when the equalizer is in the "DEFEAT". Adjustment is made by the handle 12 "BASS/TREB''.
The timbre of the low frequencies is adjusted by the knob in the half-pressed position (one push on the handle).
The timbre of high frequencies is regulated by the knob in the fully depressed position (press the handle again).
Radio
The radio is switched on by pressing button 2 "AM/FM" Pressing this button again switches the range (AM) or (FM).
Tuning radio stations
Press button 13 (up or down arrows) before the beep (the automatic search for a radio station will turn on). The search will stop when a stable signal is found. If the signal is weak, if the automatic search does not fix the setting, press the setting button again (auto search will be disabled) and adjust manually one step at a time.
Programming settings
The settings of the most frequently listened to radio stations can be memorized. To do this, tune in to the desired radio station, then press and hold one of the buttons (5 -10) to the beep. Switching to the tuned radio station is carried out by briefly pressing the desired button.
Note: if the batteries are not used for a long time, the memory of the radio is erased and the factory settings are restored.
"Favorite Station"
You can set the most frequently listened radio station to a separate button 14. When you press it, this station immediately turns on, regardless of which device worked before.
Note: new radios are set to 1620 kHz.
Setting
Using the buttons, tune in to the desired radio station, then press and hold button 14 until a beep sounds.
Note: When receiving a radio station with traffic information, the tuning and radio station selection buttons do not function. First, turn off the reception by pressing the button 14 again.
Record player
Switching the radio to the tape recorder mode is carried out by button 4 "TARE".
Playback and stop of the cassette are carried out by pressing the button 1 "PWR".
To eject the cassette, press button 15 "EJECT".
Noise reduction system
When listening to cassettes recorded using the DOLBY B NR noise reduction system, turn this system on by pressing the 12 "DOLBY". To turn off the noise reduction system, press the button again.
Reverse
Changing the playback direction of the cassette is done by pressing the button 5 "PROG".
Rewind
Press button 4 to rewind (rewind - "REW", forward - "FF" To stop rewinding, press the rewind button 4 again or the button 3 "TARE".
Melody search
This function is for jumping to any of the 9 tracks before or after the current playback location.
To do this, press button 6 "APS" so many times. how many records to go to (when navigating back, take into account the current record). Then press the rewind button 4 (to go back - to REW. forward - FF. To stop rewinding, press the rewind button again, or press the 3 "TARE").
Note: If there is a pause of less than 3 seconds between recordings or there are extraneous sounds, this function may not work properly.
Repeat Recording
To loop through the current track, press the 7 button "RPT" To turn off repeat, press the button again.
Note: If there is a pause of less than 3 seconds between recordings or there are extraneous sounds, this function may not work properly.
Skip empty seats
This function is for rewinding blank spaces on a tape. Press button 8 to turn on "SKIP". To disable the function, press the button again.
Note: This feature may not work properly if:
- The pause between recordings is less than 15 seconds.
- There are extraneous sounds between the recordings.
- The start and end of a recording cannot be clearly defined.