Camry Corolla Corona Carina Land Cruiser Highlander 4Runner RAV4 Others

Corona T190 (1992-1997)

Checking the center differential lock indicator switch sensor [Toyota Corona T190]

0

1. Check the conductivity of the sensor-switch according to the table.

Switch position	Conclusions	Conductivity
not pressed	1-2	no
pressed	1-2	there is

2. If the conductivity does not correspond to the table, replace the sensor switch.

The original source is located on the website www.ToyotaMan.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Corona T190: Mechanical gearbox

Next ▶

Checking the mechanical locking system of the interaxle differential
Transmission of 4WD models
Gearbox S50, S54 and S55 — design description
Installation of gearbox S50, S54 and S55
Removal the S50, S54 and S55 gearbox

Checking the electromagnetic valves
Checking the vacuum drive
Transfer case — design description
Gear shift lever and control cables

Similar articles on other Toyota models

➥ Checking the center differential lock sensor (4WD) Toyota Carina T190 (1992-1996)
➥ Clutch Lock Switch — Checking and Adjusting Toyota Camry XV20 (1996-2001)
➥ Checking the oil pressure indicator sensor Toyota Corolla E80 (1983-1990)
➥ Checking, adjusting and replacing the start enable switch… Toyota Cruiser 100 (1998-2007)
➥ Clutch Lock Switch — Checking, Adjusting and Replacing Toyota 4Runner N120 (1989-1995)
➥ Brake light switch (contact sensor) — checking, removing… Toyota RAV 4 XA20 (2000-2005)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Corona T190 (1992-1997)

We require cookies to enable some interactive features. Is that ok with you?