Removal and installation
1. Disconnect a wire from the negative plug of the storage battery.
2. Drain the coolant.
3. Remove the accessory drive belt.
4. Remove the viscous fan clutch.
- Tightening torque - 14 Nm
5. Remove the water pump pulley.
- Tightening torque - 14 Nm
6. Remove the timing belt.
Removal and installation of the pump of a cooling liquid (EJ-series).
1 - coolant pump,
2 - ring seal,
3 - bracket,
4 - coolant pump housing,
5 - gasket,
6 - ring seal,
7 - gasket.
7. Remove the coolant pump.
A) Turn away 3 bolts, 2 nuts and remove the pump of a cooling liquid.
- Tightening torque - 18 Nm
b) Remove the gasket.
Installation is carried out in the reverse order of removal.
Examination
1. Check that the coolant pump bearing rotates smoothly and quietly. Replace pump if necessary.
2. Check that there are no significant leaks from the drain holes. Replace pump if necessary.