Car engine cooling system Toyota Camry 2 (XV20)

Location of engine cooling system components
The engine cooling system is pressurized, the circulation of coolant is controlled by a thermostat and provided by a water pump located at the front of the cylinder block. Location of engine cooling system components 1....

Technical characteristics of the cooling system
Pressure under the radiator cap: – 4-cylinder engines 10,7 – 14,9 psi – 6-cylinder engines 12,1 – 16,4 psi Thermostat: - begins to open 80°C - completely open 96°C Tightening torques, Nm Thermostat Housing Bolts: –...

Thermostat — Checking and Replacing
Thermostat Cover Location on 4-Cylinder Models The thermostat cover on 4-cylinder models is located behind the water pump. Thermostat housing location on 6-cylinder models Thermostat housing (indicated by the arrow)...

Cooling Fans — Checking and Replacing
Location of coolant temperature sensor N1 (4-cylinder models) Coolant Temperature Sensor N1 (indicated by the arrow) located at the rear of the radiator. Location of coolant temperature sensor N1 (6-cylinder models) In...

Radiator and expansion tank — removal and installation
Removal 1. Disconnect the negative battery cable. 2. Drain the coolant. 3. Remove the upper and lower radiator hoses. 4. Disconnect the hose from the radiator filler neck. 5. Remove the cooling fan. 6. Disconnect the...

Water Pump — Removal, Checking and Installation
Water Pump - 4 Cylinder Engine 1. Bypass tube; 2. Sealing ring; 3. Gasket; 4. Inlet pipe; 5. Gasket; 6. Thermostat; 7. Adjusting plate; 8. Water pump; 9. Gasket; 10. Water pump cover; 11. Intermediate pulley N₂; 12....

Coolant temperature sensor
Examination 1. If the coolant temperature sensor is not working, check its fuse. 2. If the gauge indicator shows that the engine is hot when you just started a cold engine, disconnect the wire from the gauge (indicated...

Blower Motor Electrical Circuit
Location of the blower fan A – blower fan B – fan motor connector The blower fan is located under the glove compartment. Checking the blower motor resistor Resistor contacts Resistance 2 and 4 0.83 Ohm 2 and 3 1.12 Ohm...

Blower fan electric motor
Location of the blower fan A – blower fan B – fan motor connector The blower fan is located under the glove compartment. Removal and installation 1. Remove the interior trim panel located under the glove compartment....

This section is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Similar sections for other Toyota models

➥ Cooling and lubrication system Toyota Dyna Y50/Y60 (1984-1995)
➥ Cooling and heating Toyota RAV 4 XA20 (2000-2005)
➥ Cooling and heating Toyota Highlander 1 (2000-2007, petrol)
➥ Cooling and heating Toyota 4Runner N120 (1989-1995)
➥ Cooling system Toyota Carina T190 (1992-1996)
➥ Cooling and heating Toyota Cruiser 60/80 (1980-1997, petrol)

Link in different formats to this article

TEXTHTMLBB Code