1. Using a screwdriver, remove the boot.
2. Remove the lower ball joint from the steering knuckle
A) Remove the cotter pin and unscrew the nut.
b) Using a puller, remove the lower ball joint from the steering knuckle.
3. Using the special tool, remove the inner oil seal.
4. Remove the retaining ring.
5. Remove the hub.
A) Using the special tool, remove the hub.
b) Using the special tool and a press, remove the bearing inner race from the hub.
6. Turn away three bolts and remove a splash guard.
7. Using the special tool, remove the outer oil seal.
8. Remove the bearing from the hub.
A) Install the removed inner race first (from the side of the wheel) into the bearing.
b) Using a suitable drift and a press, remove the bearing.