Replacing fuses [Toyota Carina T190]

1. Before servicing, turn off the ignition and all electrical devices.

2. Install fuses only with the specified current rating.

Note: Do not use a fuse with a higher amperage rating or any other objects ("bugs") to replace a blown fuse. This may cause more serious damage or a fire.

3. Remove and install the fuse only with a straight movement, without twisting or rocking. Otherwise, the contacts may move too wide and the fuse will not hold in them.

Note: Use a special tool to remove and install the fuse (see picture).

4. If after replacing the fuse it burns out again, check the circuits for open circuits and short circuits.

(This material is taken from a resource: «ToyotaMan.ru»)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Carina T190: Equipment and devices

Next ▶

Precautions when working with electrical equipment of the body

Identification of connectors
Mounting block #1 (under the instrument panel)
Mounting block #2 (in the engine compartment)
Relay blocks
Checking the ignition switch