Camry Corolla Corona Carina Land Cruiser Highlander 4Runner RAV4 Others

Corona T190 (1992-1997)

Heater Fan — Removal, Installation and Checking [Toyota Corona T190]

0

Contents: Removal and installation ↓ Examination ↓

Removal and installation

Disconnect the connector, unscrew the 3 screws and remove the electric motor.

Examination

Connect the positive battery terminal to terminal 1 of the connector and the negative terminal to terminal 2. Make sure the fan rotates smoothly.

Installation is carried out in reverse order.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

The article material has been checked: Kondratyeva Ulyana

Share information:

◀ Previous

Corona T190: Heating and air conditioning

Next ▶

Expansion Valve — Checking on Vehicle
Air Conditioning Compressor — Check
Cooling Lines — Checking and Replacing
Checking the idle speed increase system
Checking the air conditioning compressor drive belt

Air intake flap servo drive
Air flow mixing flap servo drive
Air flow direction flap servo drive
Heater Fan Resistor
Ambient air temperature sensor

Similar articles on other Toyota models

➥ Checking and adjusting the idle speed when turning on the… Toyota Carina T190 (1992-1996)
➥ Checking the heater/air conditioner controls Toyota Cruiser 60/80 (1980-1997, petrol)
➥ Checking the engine oil level Toyota Camry XV20 (1996-2001)
➥ Checking the oil level Toyota Corolla E80 (1983-1990)
➥ Checking the level of operating fluids (every 400 km or… Toyota Highlander 1 (2000-2007, petrol)
➥ Checking service reminder signs Toyota 4Runner N120 (1989-1995)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Corona T190 (1992-1997)

We require cookies to enable some interactive features. Is that ok with you?